We can engrave your signature on most any engravable item.
Below is a list of Do's and Don'ts. Please read them
carefully for clean, crisp engraving.
1) We must have written permission from the owner of
each sinature before we can engrave them.
2) Please use a thin point black felt or razor point pen.
As a last resort, use a ball point that flows well.
3) Sign your signature as large as possable, so we can get all
detail. We will then reduce to size needed for engraving.
4) Please Do not sign with a light hand as this will make letters
that have very light lines that we may not be able to engrave.
5) Make sure you have no lines, marks, etc. passing through or
close to your signature, As this will only add artwork fees.
6) If suppling signature via mail, Please do not fold the paper
your signature is on as this can distort your signature.
7) Signatures must be either mailed to us or emailed as an attached,
un-compressed file in one of these formats; .pcx, .cdr, .tif, .epx,
or as a last resort, .jpg or .gif (these are listed in order of
best quality). Please do not send us copies or faxes of signatures.
If you have any questions,
please feel free to Contact us.
Engraved Signature Samples
Sample of laser engraved signatures
on faux brass plastic.
Sample of laser engraved signatures
on client supplied leather.
Sample of computer engraved signatures
on black finish brass.
Sample of computer engraved signatures
on faux burl wood plastic.
